Learn how to correct crossover when changing the tubes on a vacuum tube amplifier in this free video.

Expert: Jeff Naylor
Contact: www.Mtroniks.com
Bio: Jeff Naylor is the owner and operator of Mtroniks Engineering in Mesa, Arizona.
Filmmaker: Eric George

Duration : 0:2:7


Technorati Tags: , , , , , , ,

15 Responses to “Changing Tubes on Vacuum Tube Amplifiers : How to Correct Crossover Distortion on a Tube Amp”

  • lantyboy says:

    @melonheed3 i just …
    @melonheed3 i just get the shop to do it now lol only 20quid so its a bargin for the amount of time this needs done.

  • melonheed3 says:

    @lantyboy not …
    @lantyboy not that this helps too much but, i know there is a way to bias your amp using a voltage meter. still, another peice of equipment but i’d bet my bean bag that it’s cheaper than buying a ociloscope.

  • djematrix says:

    If replacing tubes …
    If replacing tubes is it nessasery to bias the tube’s every time or can the tube simply be replaced.?

  • soverign60 says:

    Not all tube amps …
    Not all tube amps have an adjustable bias pot. Many older amps have a resistor that must be located in the circuit. Then the tech needs to figure out the correct value for the installed tubes.

    It is best to have a tech set up the bias on a new set of tubes if you don’t know how to do it. Every set of tubes will bias at a different point – even groove tubes that have a bias number. You may be able to get by without doing a bias job, but your amp may run too hot or too cold.

  • lantyboy says:

    So does this mean i …
    So does this mean i cant do this myself??? how the am i ment to bias them with out all that gear???

  • henryflint123 says:

    that is a sine wave
    that is a sine wave

  • steelwizard says:

    Would be quite …
    Would be quite interesting hearing what crossover distortion sounds like

  • Kes1e says:

    180 would just …
    180 would just invert the wave, it would need pi/2n to match the zero crossings

  • Kes1e says:

    well changing the …
    well changing the period would just change the frequency ( period = 1/frequency ), a phase shift would change the initial displacement so the difference between a sine wave and cosine wave is 90 degrees making them equal. In the electronics world most people just refer to any oscillating wave as a sine wave.

  • unragamuf says:

    u mean same …
    u mean same amplitude and wavelength different period

  • Kes1e says:

    there both the same …
    there both the same wave just a phase shift of pi/2

  • DethDaeNossi says:

    Yea cuz there are …
    Yea cuz there are local tube amp shops all over the place.

  • laitela01 says:

    Because it contains …
    Because it contains high levels of suck

  • unragamuf says:

    that is a cosine …
    that is a cosine wave not sine

  • coronet67 says:

    Oh shit. I cant …
    Oh shit. I cant find my sine wave generator. I think I left it in my other pants.

Leave a Reply